Crown-audio DCi Series – Analog Input Models Uživatelský manuál stáhnout pdf (Strana 9)

DCi Series Power Ampliﬁers

page 9

Operation Manual

Set-up and System Conguration

Bridge Mode (16, 8, or 4 Ohm)

Typical input and output wiring, along with Attenuator and Mode DIP Switch settings are shown in Figure 7. Make sure the “Hi-Z” selector switches are in the OFF (down)

position and the Bridge (BRG) switch is in the ON (up) position. NOTE: Only the Hi-Z selector switches assigned to odd-numbered channels (1,3,5,7) are active in Bridge

mode; switches assigned to even-numbered channels (2,4,6,8) are disabled.

Figure 7 System Wiring Bridge Mode

Always route the input and output wires in separate bundles.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Operation Manual 1
Important Safety Instructions 2
DECLARATION OF CONFORMITY 3
Table of Contents 4
Installation 6
DCi Series Power Ampliﬁers 10
Precautions 12
Front Panel Features 13
Back Panel Features 13
Per Channel Settings 14
Global Settings 14
Protection System 15
Troubleshooting 16
DCi Specications 19
DCI 2300 - Bridge 21
DCI 2300 - Dual 21
DCI 2600 - Bridge 22
DCI 2600 - Dual 22
DCI 4300 - Bridge 23
DCI 4300 - Dual 23
DCI 4600 - Bridge 24
DCI 4600 - Dual 24
DCI 8300 - Bridge 25
DCI 8300 - Dual 25
DCI 8600 - Bridge 26
DCI 8600 - Dual 26
Warranty 29
PRODUCT REGISTRATION 31

Komentáře k této Příručce

Žádné komentáře

Crown-audio DCi Series – Analog Input Models Uživatelský manuál Strana 9

Komentáře k této Příručce

Související produkty a manuály pro Přijímače a zesilovače Crown-audio DCi Series – Analog Input Models